Making a Doctor Who Space Helmet

I printed the right side ear piece and sub parts, cleand them up and fitted it all together.

New printed parts and new mockup assembly With the new 3D scan I could make a new model part that I then cut the ear piece to the complex...

Scanned parts to make meeting surface There's been and ongoing issue with making the ear piece back end fit to the helmet. I could t...

I added the new smaller sized lantern and mounted it with a rubber gasket under it as seen on the original helmets. I also removed, cut down...

I've attached more of the parts I have even though some aren't perfect. But it looks kind of nice while waiting to print new and a...

New conduit end fastener modeled and printed. Compare to this screenshot (Kill the Moon).

This is the helmet with early parts as I try out attaching them with tape. The flex conduit fastener end looks a little large and...

I've printed, sanded and assembled the forehead plate and bracket. I was thinking that I should replace the dummy clamps on the ...

Now that my printer is working fully again I printed more parts. I sanded and assembled these, then I added them to the Ear piece. ...

The print quality I printed the ear piece body, but my printer had developed a minor fault causing a pitted and incomplete effect called...

I've printed and sanded some of the ear piece insert blocks and their details M8 screw to hold the printed nut and real steel ...